EasyManuals Logo

Cisco SCE 8000 User Manual

Cisco SCE 8000
248 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #75 background imageLoading...
Page #75 background image
4-13
Cisco SCE8000 GBE Installation and Configuration Guide
Chapter 4 Installing the Cisco SCE 8000 Chassis
DC-Powered Systems
Note The DC supplies each have the provision for a dual connection to the power source in order to permit
high-power operation without exceeding current ratings. For the Cisco SCE 8000, it is not necessary to
connect both of these inputs to DC power sources; it is sufficient to connect only the '1' connections.
DC-input cable Accepts 2-14 AWG copper conductors. Actual size of the wire
needed is determined by the installer or local electrician.
Terminal block material rated at 150°C (302°F).
DC-input circuit breaker For multiple DC input power supplies, each DC input must be
protected by a dedicated two-pole circuit breaker or a fuse.
The circuit breaker or the fuse must be sized according to the power
supply input power rating and any local or national electrical code
requirements.
Table 4-5 Cisco SCE 8000 DC Power Supply Specification (continued)
Specification Acceptable Range

Table of Contents

Other manuals for Cisco SCE 8000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco SCE 8000 and is the answer not in the manual?

Cisco SCE 8000 Specifications

General IconGeneral
BrandCisco
ModelSCE 8000
CategorySwitch
LanguageEnglish

Related product manuals