Administration: File Management
DHCP Auto Configuration/Image Update
112 Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4
7
DHCP Auto Configuration/Image Update
The DHCP Auto Configuration/Image Update page is used to configure the device as a DHCP
client.
The following defaults exist on the system:
• Auto Configuration is disabled.
• Auto Image Update is disabled.
• The device is enabled as a DHCP client.
• Remote SSH server authentication is disabled.
Before You Start
To use this feature, the device must either be configured as a DHCPv4 or DHCPv6 client. The
type of DHCP client defined on the device is in correlation with the type of interfaces defined
on the device.
Auto Configuration Preparations
To prepare the DHCP and TFTP/SCP servers, do the following:
TFTP/SCP Server
• Place a configuration file in the working directory. This file can be created by copying
a configuration file from a device. When the device is booted, this becomes the
Running Configuration file.
DHCP Server
Configure the DHCP server with the following options:
• DHCPv4:
- 66 (single server address) or 150 (list of server addresses)
- 67 (name of configuration file)
• DHCPv6
- Option 59 (server address)
- Options 60 (name of configuration file plus indirect image file name, separated by
a comma)
To Next Page
Loading...
Need help?
General
