EasyManuals Logo

Cisco SF350-24P Administration Guide

Cisco SF350-24P
762 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #506 background imageLoading...
Page #506 background image
Security
ARP Inspection
Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4 363
17
ARP Defaults
The following table describes the ARP defaults:
ARP Inspection Work Flow
To configure ARP Inspection:
STEP 1 Enable ARP Inspection and configure various options in the Properties page.
STEP 2 Configure interfaces as ARP trusted or untrusted in the Interfaces Settings page.
STEP 3 Add rules in the ARP Access Control Rules pages.
STEP 4 Define the VLANs on which ARP Inspection is enabled and the Access Control Rules for each
VLAN in the VLAN Settings page.
Properties
To configure ARP Inspection properties:
STEP 1 Click Security > ARP Inspection > Properties.
Enter the following fields:
ARP Inspection Status—Select to enable ARP Inspection.
ARP Packet Validation—Select to enable validation checks.
Log Buffer Interval—Select one of the following options:
- Retry FrequencyEnable sending SYSLOG messages for dropped packets.
Entered the frequency with which the messages are sent.
Option Default State
Dynamic ARP Inspection Not enabled.
ARP Packet Validation Not enabled
ARP Inspection Enabled on VLAN Not enabled
Log Buffer Interval SYSLOG message generation for
dropped packets is enabled at 5 seconds
interval

Table of Contents

Other manuals for Cisco SF350-24P

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco SF350-24P and is the answer not in the manual?

Cisco SF350-24P Specifications

General IconGeneral
ModelSF350-24P
CategorySwitch
PoE Budget195W
LayerLayer 3
Power SupplyInternal
Uplink Ports2 x combo Gigabit SFP + 2 x Gigabit
MAC Address Table Size16K entries
Jumbo Frame Support9216 bytes
ManagementWeb, CLI, SNMP
FeaturesQoS, VLAN, IPv6, ACLs
Dimensions440 mm x 257 mm x 44 mm
Operating Temperature0°C to 45°C
Operating Humidity10% to 90% non-condensing
Weight3.48 kg

Related product manuals