Cisco SG350-28P Administration Guide

Administration: Stack Management
Unit Failure in Stack
125 Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4
8
The following shows what happens when a user-assigned, master-enabled unit with Unit ID 1
joins a stack that already has a master unit with user-assigned unit ID 1. The newer Unit 1 does
not join the stack and is shutdown.
User-assigned Master-enabled Unit
Unit Failure in Stack
This section includes the following topics:
• Failure of Master Unit
• Master/Backup Switchover
• Slave Unit Handling
• Reconnecting the Original Master Unit After Failover
Failure of Master Unit
If the Master fails, the backup unit takes over the master role and continues to operate the stack
normally.
For the backup to be able to take the place of the master, both units maintain a warm standby at
all times. In warm standby, the master and its backup units are synchronized with the static
configuration (contained in both the Startup and Running configuration files). Backup
configuration files are not synchronized. The backup configuration file remains on the
previous master.
Dynamic process-state information, such as the STP state table, dynamically-learned MAC
addresses, dynamically-learned Smartport types, MAC Multicast tables, LACP, and GVRP are
not synchronized.

Cisco SG350-28P Specifications

General

Model	SG350-28P
Category	Switch
Ports	28
PoE Ports	24
PoE Budget	195W
Switching Capacity	56 Gbps
Forwarding Rate	41.67 Mpps
Layer	Layer 3
Rack Mountable	Yes
Gigabit Ethernet Ports	28
MAC Address Table Size	16K
Power Supply	Internal
Jumbo Frame Support	Yes
Dimensions (W x D x H)	440 x 257 x 44 mm
Operating Temperature	0°C to 40°C
Storage Temperature	-20°C to 70°C
Humidity	10% to 90% non-condensing