Cisco SG350-28P Administration Guide

Administration: Time Settings
Recurring Time Range
126 Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4
8
• Absolute Starting Time—To define the start time, enter the following:
- Immediate—Select for the time range to start immediately.
- Date, Time—Enter the date and time that the Time Range begins.
• Absolute Ending Time—To define the start time, enter the following:
- Infinite—Select for the time range to never end.
- Date, Time—Enter the date and time that the Time Range ends.
STEP 4 Click Apply.
STEP 5 To add a recurring time range, click Recurring Range.
Recurring Time Range
A recurring time element can be added to an absolute time range. This limits the operation to
certain time periods within the absolute range.
To add a recurring time range element to an absolute time range:
STEP 1 Click Administration > Time Settings > Recurring Range.
The existing recurring time ranges are displayed (filtered per a specific, absolute time range.)
STEP 2 Select the absolute time range to which to add the recurring range.
STEP 3 To add a new recurring time range, click Add.
STEP 4 Enter the following fields:
• Recurring Starting Time—Enter the date and time that the Time Range begins on a
recurring basis.
• Recurring Ending Time—Enter the date and time that the Time Range ends on a
recurring basis.
STEP 5 Click Apply.
STEP 6 Click Time Range to access the Absolute Time Range page.

Cisco SG350-28P Specifications

General

Model	SG350-28P
Category	Switch
Ports	28
PoE Ports	24
PoE Budget	195W
Switching Capacity	56 Gbps
Forwarding Rate	41.67 Mpps
Layer	Layer 3
Rack Mountable	Yes
Gigabit Ethernet Ports	28
MAC Address Table Size	16K
Power Supply	Internal
Jumbo Frame Support	Yes
Dimensions (W x D x H)	440 x 257 x 44 mm
Operating Temperature	0°C to 40°C
Storage Temperature	-20°C to 70°C
Humidity	10% to 90% non-condensing