Cisco SG350-28P Administration Guide

24
Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4 444
SNMP
This section describes the Simple Network Management Protocol (SNMP) feature that
provides a method for managing network devices.
It covers the following topics:
•Overview
•Engine ID
•Views
•Groups
•Users
• Communities
• Trap Settings
• Notification Recipients
• Notification Filter
Overview
SNMP Versions and Workflow
The device functions as SNMP agent and supports SNMPv1, v2, and v3. It also reports system
events to trap receivers using the traps defined in the supported MIBs (Management
Information Base).
SNMPv1 and v2
To control access to the system, a list of community entries is defined. Each community entry
consists of a community string and its access privilege. The system responds only to SNMP
messages specifying the community which has the correct permissions and correct operation.

Cisco SG350-28P Specifications

General

Model	SG350-28P
Category	Switch
Ports	28
PoE Ports	24
PoE Budget	195W
Switching Capacity	56 Gbps
Forwarding Rate	41.67 Mpps
Layer	Layer 3
Rack Mountable	Yes
Gigabit Ethernet Ports	28
MAC Address Table Size	16K
Power Supply	Internal
Jumbo Frame Support	Yes
Dimensions (W x D x H)	440 x 257 x 44 mm
Operating Temperature	0°C to 40°C
Storage Temperature	-20°C to 70°C
Humidity	10% to 90% non-condensing