Cisco SG350-28P Administration Guide

Port Management
PoE
184 Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4
10
PoE
This section describes how to use the PoE feature.
NOTE PoE is only supported on standalone devices, meaning devices that are not part of a stack.
It covers the following topics:
•Overview
• PoE Properties
• Settings
• Statistics
• Green Ethernet Overview
Overview
A PoE device is Power Sourcing Equipment (PSE) that delivers electrical power to a
connected Pod Devices (PD) over existing copper cables without interfering with the network
traffic, updating the physical network or modifying the network infrastructure.
Features
PoE provides the following features:
• Eliminates the need to run 110/220 V AC power to all devices on a wired LAN.
• Removes the necessity for placing all network devices next to power sources.
• Eliminates the need to deploy double cabling systems in an enterprise significantly
decreasing installation costs.
Power over Ethernet can be used in any enterprise network that deploys relatively low-pod
devices connected to the Ethernet LAN, such as:
• IP phones
• Wireless access points
• IP gateways
• Audio and video remote monitoring devices

Cisco SG350-28P Specifications

General

Model	SG350-28P
Category	Switch
Ports	28
PoE Ports	24
PoE Budget	195W
Switching Capacity	56 Gbps
Forwarding Rate	41.67 Mpps
Layer	Layer 3
Rack Mountable	Yes
Gigabit Ethernet Ports	28
MAC Address Table Size	16K
Power Supply	Internal
Jumbo Frame Support	Yes
Dimensions (W x D x H)	440 x 257 x 44 mm
Operating Temperature	0°C to 40°C
Storage Temperature	-20°C to 70°C
Humidity	10% to 90% non-condensing