Cisco SG350-28P Administration Guide

15
Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4 260
Multicast
This section describes the Multicast Forwarding feature, and covers the following topics:
• Multicast Forwarding Overview
• Properties
• MAC Group Address
• IP Multicast Group Address
• IPv4 Multicast Configuration
• IPv6 Multicast Configuration
• IGMP/MLD Snooping IP Multicast Group
• Multicast Router Port
• Forward All
• Unregistered Multicast
Multicast Forwarding Overview
Multicast forwarding enables one-to-many information dissemination. Multicast applications
are useful for dissemination of information to multiple clients, where clients do not require
reception of the entire content. A typical application is a cable-TV-like service, where clients
can join a channel in the middle of a transmission, and leave before it ends.
The data is sent only to relevant ports. Forwarding the data only to the relevant ports conserves
bandwidth and host resources on links.
By default, all Multicast frames are flooded to all ports of the VLAN. It is possible to
selectively forward only to relevant ports and filter (drop) the Multicast on the rest of the ports
by enabling the Bridge Multicast filtering status in the Properties page.

Cisco SG350-28P Specifications

General

Model	SG350-28P
Category	Switch
Ports	28
PoE Ports	24
PoE Budget	195W
Switching Capacity	56 Gbps
Forwarding Rate	41.67 Mpps
Layer	Layer 3
Rack Mountable	Yes
Gigabit Ethernet Ports	28
MAC Address Table Size	16K
Power Supply	Internal
Jumbo Frame Support	Yes
Dimensions (W x D x H)	440 x 257 x 44 mm
Operating Temperature	0°C to 40°C
Storage Temperature	-20°C to 70°C
Humidity	10% to 90% non-condensing