Cisco Small Business AP541N - Page 103

SNMP
Configuring SNMP on the Access Point
98 Cisco AP541N Dual-band Single-radio Access Point Quick Start Guide
5
Figure 21 Modifying SNMP Settings
Table 25 SNMP S et tings
Field Description
SNMP
Enabled/Disabled
You can specify the SNMP administrative mode on your
network. By default SNMP is disabled. To enable SNMP,
click Enabled. To disable SNMP, click Disabled
. After
changing the mode, y
ou must click Apply to save your
configuration changes.
NOTE: If you disable SNMP, all remaining fields on the
SNMP page are disabled. This is a global SNMP
parameter that applies to SNMPv1, SNMPv2c, and
SNMPv3.