SNMP
SNMP Targets
108 Cisco AP541N Dual-band Single-radio Access Point Quick Start Guide
5
SNMP Targets
SNMPv3 Targets send trap messages to the SNMP manager. Each target is
identified by a target name and associated with target IP address, UDP port, and
SNMP user name.
Figure 25 SNMPv3 Target
Table 29 SNMP v3 Targets
Field Description
IP Address Enter the IP address of the remote SNMP manager to receive
the target.
Port Enter the UDP port to use for sending SNMP targets.
Users Enter the name of the SNMP user to associate with the target.To
configure SNMP users, see Configuring SNMP Users, page
106.
SNMPv3 Targets This field shows the SNMPv3 Targets on the access point. To
remove a target, select it and click Remove.
To Next Page
Loading...
