Cisco Small Business AP541N - Chapter 8: Configuration Examples

8
Cisco AP541N Dual-band Single-radio Access Point Quick Start Guide 149
Configuration Examples
This chapter contains examples of how to configure selected features available on
the access point. Each example contains procedures on how to configure the
feature by using the Access Point Configuration Utility, or SNMP.
This chapter describes how to perform the following procedures:
• Configuring a VAP
• Configuring Wireless Radio Settings
• Configuring the Wireless Distribution System
• Clustering Access Points
For all SNMP examples, the objects you use to modify the access point are in a
private MIB. The path to the tables that contain the objects is
iso(1).org(3).dod(6).internet(1).private(4).enterprises(1).lvl7(6132).lvl7Products(1).fas
tPath(1).fastPathWLANAP(28), as shown in Figure 38.