Cisco Small Business AP541N - VAP Configuration Using SNMP

Configuration Examples
Configuring a VAP
152 Cisco AP541N Dual-band Single-radio Access Point Quick Start Guide
8
STEP 8 Click Apply to update the access point with the new settings.
VAP Configuration Using SNMP
STEP 1 Load the FASTPATH-WLAN-ACCESS-POINT-MIB module.
STEP 2 From the MIB tree, navigate to the objects in the apVap table.
STEP 3 Walk the apVapDescription object to view the instance ID for VAP 2 (wlan0vap2).
VAP 2 on wireless Radio 1 is instance 5.
STEP 4 Use the apVapStatus object to set the status of VAP 2 to up (1).
STEP 5 Use the apVapVlanID object to set the VLAN ID of VAP 2 to 2.
STEP 6 Navigate to the objects in the apIfConfig table.
STEP 7 Walk the apIfConfigName object to view the instance ID for VAP 2 (wlan0vap2).
VAP 2 on wireless Radio 1 is instance 7.
STEP 8 Set the value of instance 7 in the apIfConfigSsid object to Marketing.
STEP 9 Set the value of instance 7 in the apIfConfigSecurity object to wpa-personal (3).
STEP 10 Set the value of instance 7 in the apIfConfigWpaPersonalKey object to
JuPXkC7GvY$moQiUttp2, which is the WPA pre-shared key.
STEP 11 Navigate to the objects in the apRadioBss > apBssTable table.
STEP 12 Walk the apBssDescr object to view the instance ID for VAP 2.
VAP 2 on wireless Radio 1 is instance 3.