Cisco Small Business AP541N - Clustering Access Points; Clustering Aps by Using the Web Interface

Configuration Examples
Clustering Access Points
158 Cisco AP541N Dual-band Single-radio Access Point Quick Start Guide
8
Clustering Access Points
This example shows how to configure a cluster with two APs and to enable
automatic channel re-assigment.The location of the local access point is Room
214, and the cluster name is MyCluster.
Clustering APs by Using the Web Interface
STEP 1 Log onto the access point and navigate to the Cluster > Access Points page.
STEP 2 Enter the access point location and the name of the cluster for it to join.
STEP 3 Click Apply.
STEP 4 Click Enable Clustering to enable the clustering feature.
After you refresh the page, other APs that are on the same bridged segment, have
wireless radios in the same operating mode, are enabled for clustering, and have
the same cluster name appear in the Access Points table.