Cisco Small Business AP541N - Configuring Persistent Logging Options

Administration
Event Logs
Cisco AP541N Dual-band Single-radio Access Point Quick Start Guide 121
6
Click Refresh to refresh the page.
NOTE The access point acquires its date and time information using the network time
protocol (NTP). This data is reported in UTC format (also known as Greenwich Mean
Time). You need to convert the reported time to your local time. For information on
setting the network time protocol, see Enabling the Network Time Protocol,
page 41.
Configuring Persistent Logging Options
If the system unexpectedly reboots, log messages can help you diagnose the
cause. However, log messages are erased when the system reboots unless you
enable persistent logging.
WARNING Enabling persistent logging can wear out the flash (non-volatile) memory and
degrade network performance. You should only enable persistent logging to debug
a problem. Make sure you disable persistent logging after you finish debugging the
problem.
To configure persistent logging on the Event Logs page, set the persistence,
severity, and depth options as described in Table 31, and then click Apply.
Figure 29 Persistent Logging Options