Cisco Small Business AP541N - Configuring Security on the Wireless Access Point

Getting Started
Configuring Security on the Wireless Access Point
Cisco AP541N Dual-band Single-radio Access Point Quick Start Guide 19
1
!
CAUTION By default, no security is in place on the access point, so any wireless client can
associate with it and access your LAN, including unauthorized devices. An
important next step is to configure security. Continue with Configuring Security on
the Wireless Access Point, page 19 for more information.
Configuring Security on the Wireless Access Point
You configure secure wireless client access by configuring security for each
virtual access point (VAP) that you enable. You can configure up to 16 VAPs per
wireless radio that simulate multiple access points in one physical access point.
For each VAP, you can configure a unique security mode to control wireless client
access.
Each wireles s radio has 16 VAPs , with VAP IDs from 0-15. VAP 0, VAP 1, and VAP 2
have dif ferent defa ult settings than VAPs 3-15. By default , VAP 0, VAP 1, and VAP 2
are enabled.
VAP0 has the following default settings:
• VLAN ID: 1
• SSID: cisco-data
• Broadcast SSID: Enabled
• Security: None
• MAC Authentication Type: Disabled
• Station Isolation: Disabled
• HTTP Redirect: Disable
VAP1 has the following default settings:
• VLAN ID: 100
• SSID: cisco-voice
• Broadcast SSID: Enabled
• Security: None
• MAC Authentication Type: Disabled