Getting Started
Configuring Security on the Wireless Access Point
20 Cisco AP541N Dual-band Single-radio Access Point Quick Start Guide
1
• Station Isolation: Disabled
• HTTP Redirect: Disable
VAP2 has the following default settings:
• VLAN ID: 1
• SSID: cisco-scan
• Broadcast SSID: Enabled
• Security: WPA Personal
• WPA Versions: WPA2
• Cipher Suites: CCMP (AES)
• Key: intermec
• MAC Authentication Type: Disabled
• Station Isolation: Disabled
• HTTP Redirect: Disable
VAP3-15 are disabeld by default, but when they are enabled they will have the
following default settings:
• VLAN ID: 1
• SSID: Virtual Access Point x ( where x is the VAP ID)
• Broadcast SSID: Enabled
• Security: None
• MAC Authentication Type: Disabled
• Station Isolation: Disabled
• HTTP Redirect: Disable
To prevent unauthorized access to the access point, we recommend that you
select and configure a security option other than None for the default VAP and for
each VAP that you enable.
For information about how to configure the security settings on each VAP, see
Configuring the Wireless Distribution System, page 85.
To Next Page
Loading...
