Cisco Small Business AP541N - Cisco AP541 N Installation and Reset; Resetting AP to Factory Defaults; Cisco AP541 N Installation Overview

Getting Started
Connecting the Access Point to a PC
6 Cisco AP541N Dual-band Single-radio Access Point Quick Start Guide
1
Launching the Access Point Configuration Utility
This section contains information for the for launching the Access Point
Configuration Utility:
• Using the default static IP address of the switch. Follow the instructions in the
“Display the Configuration Utility By Using the Default IP Address”
section.
• Using Cisco Configuration Assistant (CCA). Follow the instructions in the
“Display the Configuration Utility by Using Cisco Configuration Assistant
2.1 or higher” section.
• Using the an IP address assigned to the switch through DHCP. Follow the
instructions in the “Display the Configuration Utility by Using Another IP
Address” section.
Display the Configuration Utility By Using the Default IP
Address
To a c c e s s t h e Access Point Configuration Utility, enter the default static IP
address of the access point into a Web browser, do the following:
STEP 1 Enter the Cisco AP541N default static IP address in the address bar and press Enter. For
example, http://
192.168.10.10.
The Login window displays, as shown in Figure 3.