Cisco Small Business AP541N - Enabling or Disabling the Log Relay Host on the Events Page

Administration
Event Logs
124 Cisco AP541N Dual-band Single-radio Access Point Quick Start Guide
6
Enabling or Disabling the Log Relay Host on the Events Page
To enable and configure Log Relaying on the Event Logs page, set the Log Relay
options as described in Log Relay Host, page 124, and then click Apply.
Figure 30 Log Relay Host
NOTE To apply your changes, click Apply. Changing some settings might cause the
access point to stop and restart system processes. If this happens, wireless clients
will temporarily lose connectivity. We recommend that you change access point
settings when WLAN traffic is low.
Table 32 Log Relay Host
Field Description
Relay Log
Choose to either enable or disable use of the Log Relay Host.
If you select the Relay Log radio button, the Log Relay Host is
enabled and the Relay Host and Relay Port fields are
editable.
Relay Host
Specify the IP Address or DNS name of the remote log
server.
Relay Port
Specify the Port number for the syslog process on the Relay
Host. The default port is 514.