Cisco Small Business AP541N - Page 110

SNMP
Configuring SNMP on the Access Point
Cisco AP541N Dual-band Single-radio Access Point Quick Start Guide 105
5
NOTE After you configure the SNMPv3 Groups settings, you must click Apply to apply the
changes and to save the settings.
Security Level
Select one of the following security levels for the
group:
noAuthentication-noPrivacy—No authentication and
no data encryption (no security).
Authentication-noPrivacy—Authentication, but no data
encryption. With this security level, users send SNMP
messages that use an MD5 key/password for
authentication, but not a DES key/password for
encryption.
Authentication-Privacy—Authentication and data
encryption. With this security level, users send an MD5
key/password for authentication and a DES key/
password for encryption.
For groups that require authentication, encryption, or
both, you must define the MD5 and DES key/
passwords on the SNMPv3 Users page.
Write Views
Select the write access to management objects (MIBs)
for the group:
write-all—The group can create, alter, and delete MIBs.
write-none—The group is not allowed to create, alter, or
delete MIBS.
Read Views
Select the read access to management objects (MIBs)
for the group:
view-all—The group is allowed to view and read all
MIBs.
view-none—The group cannot view or read MIBs.
SNMPv3 Groups
This field shows the default groups and the groups
that you have defined on the access point. To remove
a group, select the group and click Remove.
Table 27 SNMP v3 G roups
Field Description