Getting Started
Connecting the Access Point to a PC
10 Cisco AP541N Dual-band Single-radio Access Point Quick Start Guide
1
When you have connected to the CCA site and the devices have been discovered,
the Topology Map includes the Cisco AP541N.
NOTE Non-Cisco devices connected to the switch are not shown in the Topology
map.
STEP 7 Right-click the access point to display the options: Configuration Utility, Properties,
and Annotation.
STEP 8 Click Configuration Utility.
The Access Point Configuration Utility
displays in a new window, as shown in
Figure 4.
Next, we recommend that you:
• Change the password by clicking Change Administrator Password.
• Configure the SSID and enable wireless security, by clicking Configure
Wireless Networks (SSIDs).
• Enable the wireless radio, by clicking Enable Wireless Radio.
• Assign a new static IP address to the access point if your network devices
are configured with static IP addresses, by clicking Set LAN IP Address.
To Next Page
Loading...
