Setup
Enabling the Network Time Protocol
44 Cisco AP541N Dual-band Single-radio Access Point Quick Start Guide
3
Table 9 TIme Settings (NTP)
Field Description
System Time Shows the current system time.
Set System Time To permit the AP to poll an NTP server, click Using
Network Time Protocol (NTP).
To set the system time manually, click Manually.
NTP Server This field appears when you select Using Network
Time Protocol (NTP) in the Set System Time field.
If using NTP, specify the server by host name or IP
address.
Using the IP address is not recommended as the IP
address is more likely to change.
Time Zone Select the international time zone in which the AP is
operating, for example USA (Eastern).
System Date This field appears when you select Manually in the
Set System Time field. Use the System Date list to
select month, day, and year.
System Time (24 HR) This field appears when you select Manually in the
Set System Time field. Use the System Time list to
select hours and minutes. All times are relative to the
local time zone.
To Next Page
Loading...
