Wireless
Modifying Wireless Radio Settings
Cisco AP541N Dual-band Single-radio Access Point Quick Start Guide 49
4
Mode
The Physical Layer (PHY) standard the wireless radio uses.
NOTE: If the Wireless Radio Interface is set to Off, the Mode
cannot be changed.
NOTE: The modes available on your access point depend on
the country code setting.
Select one of the following modes for the wireless radio
interface:
• 802.11a. Only 802.11a clients can connect to the access
point.
• 802.11b/g. 802.11b and 802.11g clients can connect to
the access point.
• 802.11a/n. 802.11a clients and 802.11n clients operating
in the 5-GHz frequency can connect to the access point.
• 802.11b/g/n (default). 802.11b, 802.11g, and 802.11n
clients operating in the 2.4-GHz frequency can connect
to the access point.
• 2.4 GHz 802.11n. Only 802.11n clients operating in the
2.4-GHz frequency can connect to the access point.
• 5 GHz 802.11n.Only 802.11n clients operating in the 5-
GHz frequency can connect to the access point.
Table 10 Radio Settings Field Descriptions
Field Description
To Next Page
Loading...
