Wireless
Modifying Advanced Settings
76 Cisco AP541N Dual-band Single-radio Access Point Quick Start Guide
4
Table 19 Advanced Settings Field Descriptions
Field Description
Status (On/Off)
Specify whether you want the wireless radio on or off by
clicking On or Off.
If you turn off a wireless radio, the access point sends
disassociation frames to all the wireless clients it was
supporting so that the wireless radio can be gracefully
shutdown and the clients can start the association process
with other available access points.
NOTE: If Status is set to Off, then all fields are not able to be
edited.
Mode
The Mode defines the Physical Layer (PHY) standard used
by the wireless radio.
NOTE: The modes available on your access point depend
on the country code setting.
Select one of the following modes for the wireless radio
interface:
• 802.11a
• 802.11b/g
• 802.11a/n
• 802.11b/g/n
• 5 GHz 802.11n
• 2.4 GHz 802.11n
To Next Page
Loading...
