Cisco SPA303 User Manual

Using Advanced Phone Features
Customizing Your LCD Screen (Cisco SPA 303)
Cisco Small Business IP Phone SPA 30X User Guide (SPCP) 45
4
To configure your screen saver:
STEP 1 Press the Setup button.
STEP 2 Scroll to Settings and press the Select softkey.
STEP 3 Scroll to Screen Saver Mode and press the Select softkey.
STEP 4 To change the status of your screen saver:
a. Scroll to Enable Screen Saver and press the Edit softkey.
b. Press the Y/ N softkey until the desired option appears: Ye s to enable a screen
saver or No to disable this feature.
c. Press the OK softkey.
d. Press the Save softkey to save your changes.
STEP 5 To specify the amount of idle time that can elapse before the screen saver
appears:
a. Scroll to Screen Saver Wait Time and press the Edit softkey.
b. Clear the displayed time by pressing the Clear softkey.
c. Enter the idle time period in minutes by pressing numbers on the keypad.
d. Press the OK softkey.
e. Press the Save softkey to save your changes.
Turning on the Screen Saver Immediately
To immediately turn on your phone’s screen saver without waiting for the specified
Screen Saver Wait Time to elapse:
NOTE The screen saver must be enabled in order to immediately activate it.
STEP 1 Press the Setup button.
STEP 2 Scroll to Screen Saver Mode.
STEP 3 Press the Activate softkey.

Cisco SPA303 Specifications

General

Display	Monochrome LCD
Lines	3
Speakerphone	Yes
Headset Jack	Yes (2.5 mm)
Handset	Yes
Ethernet Ports	2 x 10/100 Mbps
Protocol	SIP
Power	Power over Ethernet (PoE) or AC adapter
Audio Codec Support	G.711, G.729
QoS	802.1p/q