Cisco SX10 Quick Set - Systemunit Settings; Systemunit Irsensor; Systemunit Name

D15330.06 SX10 Administrator Guide CE9.1, JUNE 2017. www.cisco.com — Copyright © 2017 Cisco Systems, Inc. All rights reserved.
112
Cisco TelePresence SX10 Quick Set Administrator Guide
SystemUnit settings
SystemUnit Name
Define the system name. The system name will be sent as the hostname in a DHCP request
and when the codec is acting as an SNMP Agent.
Requires user role: ADMIN
Default value: ""
Value space: String (0, 50)
Define the system name.
SystemUnit IrSensor
The codec has a short-range IR sensor underneath the power button. It may be used with
the remote control, but it is not intended for regular operation. It should be used only when
required for troubleshooting or system recovery. In regular operation, the IR sensor on the
camera should be used with the remote control, refer to the Cameras Camera [1] IrSensor
setting.
Requires user role: ADMIN
Default value: Auto
Value space: Auto/Off/On
Auto: The IR sensor of the codec is disabled whenever the IR sensor of the camera is
enabled. The IR sensor of the codec is enabled only if the IR sensor of the camera is
disabled.
Off: Disable the IR sensor of the codec.
On: Enable the IR sensor of the codec.
Introduction
Configuration
Peripherals
Maintenance
System settings
Appendices

System settings