D15330.06 SX10 Administrator Guide CE9.1, JUNE 2017. www.cisco.com — Copyright © 2017 Cisco Systems, Inc. All rights reserved.
96
Cisco TelePresence SX10 Quick Set Administrator Guide
Peripherals Profile Cameras
Define the number of cameras that are expected to be connected to the video system.
This information is used by the video system's diagnostics service. If the number of
connected cameras does not match this setting, the diagnostics service will report it as an
inconsistency.
Requires user role: ADMIN, INTEGRATOR
Default value: Minimum1
Value space: NotSet/Minimum1/0/1/2/3/4/5/6/7
NotSet: No camera check is performed.
Minimum1: At least one camera should be connected to the video system.
0-7: Select the number of cameras that are expected to be connected to the video
system.
Peripherals Profile ControlSystems
Define if a third-party control system, for example Crestron or AMX, is expected to be
connected to the video system. This information is used by the video system's diagnostics
service. If the number of connected control systems does not match this setting, the
diagnostics service will report it as an inconsistency. Note that only one third-party control
system is supported.
If set to 1, the control system must send heart beats to the video system using xCommand
Peripherals Pair and HeartBeat commands. Failing to do so will cause the in-room control
extensions to show a warning that the video system has lost connectivity to the control
system.
Requires user role: ADMIN, INTEGRATOR
Default value: NotSet
Value space: 1/NotSet
1: One third-party control system should be connected to the video system.
NotSet: No check for a third-party control system is performed.
Peripherals Profile TouchPanels
Define the number of Cisco Touch controllers that are expected to be connected to the
video system. This information is used by the video system's diagnostics service. If the
number of connected Touch controllers does not match this setting, the diagnostics service
will report it as an inconsistency.
Requires user role: ADMIN, INTEGRATOR
Default value: NotSet
Value space: NotSet/Minimum1/0/1/2/3/4/5
NotSet: No touch panel check is performed.
Minimum1: At least one Cisco Touch controller should be connected to the video system.
0-5: Select the number of Touch controllers that are expected to be connected to the
video system. Note that only one Cisco Touch controller is officially supported.
To Next Page
Loading...
