Cisco TelePresence MX700 - Xconfiguration Serialport Loginrequired; SIP Configuration; Xconfiguration SIP Authentication Username; Xconfiguration SIP Authentication Password

D15335.02 Cisco TelePresence MX700 and MX800 API Reference Guide CE8.0, FEBRUARY 2016.
Copyright © 2016 Cisco Systems, Inc. All rights reserved. 73
Cisco TelePresence MX700 and MX800
API Reference Guide
xConfiguration SerialPort LoginRequired
Define if login shall be required when connecting to the serial port.
Requires user role: ADMIN
Default value: On
USAGE:
xConfiguration SerialPort LoginRequired: LoginRequired
where
LoginRequired : Off/On
Off: The user can access the codec via the serial port without any login.
On: Login is required when connecting to the codec via the serial port.
SIP configuration
xConfiguration SIP Authentication UserName
This is the user name part of the credentials used to authenticate towards the SIP proxy.
Requires user role: ADMIN
Default value: ""
USAGE:
xConfiguration SIP Authentication UserName: "UserName"
where
UserName : String (0, 128)
A valid username.
xConfiguration SIP Authentication Password
This is the password part of the credentials used to authenticate towards the SIP proxy.
Requires user role: ADMIN
Default value: ""
USAGE:
xConfiguration SIP Authentication Password: "Password"
where
Password : String (0, 128)
A valid password.
Introduction
About the API
xConfiguration
Appendices
xCommand
xStatus

xConfiguration