Cisco TelePresence MX700 User Manual

D15335.02 Cisco TelePresence MX700 and MX800 API Reference Guide CE8.0, FEBRUARY 2016.
Copyright © 2016 Cisco Systems, Inc. All rights reserved. 76
Cisco TelePresence MX700 and MX800
API Reference Guide
xConfiguration SIP URI
The SIP URI (Uniform Resource Identifier) is the address that is used to identify the video
system. The URI is registered and used by the SIP services to route inbound calls to the system.
The SIP URI syntax is defined in RFC 3261.
Requires user role: ADMIN
Default value: ""
USAGE:
xConfiguration SIP U R I: "URI"
where
URI : String (0, 255)
An address (URI) that is compliant with the SIP URI syntax.
Standby configuration
xConfiguration Standby Control
Define whether the system should go into standby mode or not.
Requires user role: ADMIN
Default value: On
USAGE:
xConfiguration Standby Control: Control
where
Control : Off/On
Off: The system will not enter standby mode.
On: The system will enter standby mode when the Standby Delay has timed out.
Requires the Standby Delay to be set to an appropriate value.
xConfiguration Standby Delay
Define how long (in minutes) the system shall be in idle mode before it goes into standby mode.
Requires the Standby Control to be enabled.
Requires user role: ADMIN
Default value: 10
USAGE:
xConfiguration Standby Delay: Delay
where
Delay : Integer (1..480)
Set the standby delay (minutes).
Introduction
About the API
xConfiguration
Appendices
xCommand
xStatus

xConfiguration

Cisco TelePresence MX700 Specifications

General

Product Type	Video conferencing system
Frame Rate	Up to 60 fps
Display	Dual 55-inch LCD
Audio	Integrated speakers and microphones
Video Standards	H.264
Network	Ethernet
Connectivity	HDMI, USB
Control	Touch 10 control unit
Video Resolution	1080p at 60 fps
Zoom	12x optical zoom
Codec	H.264
Network Protocols	SIP
Power Consumption	300W
Weight	90 kg