Restarting the E-Series Server Installed in a Cisco 3900 Series ISR G2
If the oir-stop command is issued and the E-Series Server is not physically removed from the slot, you can
restart the E-Series Server with the oir-start command. From a console terminal, issue the hw-module sm
slot oir-start command. The console displays the module’s changing state.
Router# hw-module sm 2 oir-start
Router#
*Mar 8 05:40:19.195: %LINK-3-UPDOWN: Interface ucse2/0, changed state to up
*Mar 8 05:40:20.195: %LINEPROTO-5-UPDOWN: Line protocol on Interface ucse2/0, changed
state to up
Inserting the E-Series Server in a Cisco 3900 Series ISR G2
The Cisco 3900 ISR G2 that is up and running can detect when an E-Series Server is inserted in the SM slot
and will automatically provide power to the server.
Removing the E-Series Server from a Cisco ISR 4000 Series
Shutting Down the E-Series Server Installed in a Cisco ISR 4000 Series
Procedure
PurposeCommand or Action
Enables privileged EXEC mode.enable
Step 1
Example:
Enter your password if prompted.
Router> enable
Shuts down the E-Series Server gracefully.
ucse subslot slot/0 shutdown
Step 2
Example:
Before proceeding with the next
command, verify that the E-Series
Server has shut down. When the
E-Series Server shuts down, the
power LED turns orange. You can
also use CIMC to verify if the
E-Series Server has powered down.
Note
Router# ucse subslot 1/0 shutdown
Shuts down power to the specified E-Series
Server to prepare it for removal.
hw-module subslot slot/0 stop
Example:
Step 3
When it is safe to remove the E-Series Server,
a message is displayed as shown in the example.
Router# hw-module subslot 1/0 stop
Before removing the E-Series
Server, verify that power to the slot
is shut down. The power LED should
be off.
Note
Example:
SM Hardware slot 0 can be removed
Cisco UCS E-Series Servers and the Cisco UCS E-Series Network Compute Engine Hardware Installation Guide
36
Restarting the E-Series Server Installed in a Cisco 3900 Series ISR G2
To Next Page
Loading...
