Step 2
Position the chassis on the rack to align the holes on the short leg of the bracket with the appropriate holes
on the 19-inch rack.
Step 3
Using the machine screws (not supplied), attach the bracket to the rack to secure the chassis in the rack. (See
the following figure.)
Figure 9: Attaching the Chassis to the 19-Inch Rack
Mounting the Chassis on a Wall
Before You Begin
This unit is intended to be mounted on a wall. Read the wall-mounting instructions carefully before
beginning installation. Failure to use the correct hardware or to follow the correct procedures could result
in a hazardous situation to people and damage to the system. Statement 248
Warning
Ensure that the chassis is oriented with the back panel connectors aligned sideways and not facing vertically
upward or downward.
Caution
Two types of mounting screws are provided in separate packages to attach the mounting brackets to the
chassis. Take care to use the correct screw type and washers for the required mounting option (rack
mounting or wall mounting). For more information, see Mounting Screws, on page 28.
Caution
You must arrange for the fasteners required to install the chassis on a wall. These fasteners are not included
in the package. We recommend that you select the fasteners that are appropriate for the material the wall
is made of.
Note
To mount the chassis on a wall:
Cisco VG310 and Cisco VG320 Voice Gateways Hardware Installation Guide
30 OL-31292-01
Installing the Cisco VG310 and Cisco VG320 Voice Gateways
Mounting the Chassis on a Wall
To Next Page
Loading...
Need help?
General
