Cisco VG310 User Manual

CHAPTER 4
Configuring the Cisco VG310 and Cisco VG320
Voice Gateways
This chapter describes how to power up the Cisco VG310 and Cisco VG320 and perform the initial
configuration in the following sections:
•
Getting Your Network Information, page 53
•
Checklist for Power Up, page 53
•
Power-On Procedure, page 54
•
Performing the Initial Configuration on the Voice Gateway, page 55
•
Troubleshooting Cisco VG310 and Cisco VG320, page 59
Getting Your Network Information
Before you begin the configuration process, get the IP address for the 10/100/1000BASE-T ports.
Checklist for Power Up
Check the following items before powering up Cisco VG310 or Cisco VG320:
•
Chassis is securely mounted and grounded.
•
Power and interface cables are connected.
•
The external CompactFlash memory card is properly seated into its slot.
•
PC with terminal-emulation program (HyperTerminal or equivalent) is connected to the console port
and configured for 9600 baud, 8 data bits, 1 stop bit, no parity, and flow control is set to None.
•
Suitable PC COM port is selected in the terminal-emulation program.
•
Passwords for access control are selected.
•
IP addresses for the Ethernet and serial interfaces have been determined.
Cisco VG310 and Cisco VG320 Voice Gateways Hardware Installation Guide
OL-31292-01 53

Cisco VG310 Specifications

General

Number of Ports	24 FXS ports
Network Protocols	SIP, MGCP, H.323
Form Factor	Rack-mountable
Operating Temperature	32 to 104°F (0 to 40°C)
Storage Temperature	-4 to 149°F (-20 to 65°C)
Power Supply	AC 100 to 240 VAC, 50 to 60 Hz
Ethernet Ports	2 x 10/100/1000 Ethernet ports
Humidity	10 to 90% non-condensing
Compliance	FCC, CE, UL