Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Step 3
To continue with the configuration, enter yes.
The following message is displayed:
Would you like to enter basic management setup? [yes/no]:
Basic management setup configures the minimum settings required for connectivity.Note
Step 4
Enter yes to continue.
The following message is displayed:
Configuring global parameters:
Enter host name [Router]:
Step 5
Enter a hostname for the voice gateway.
The following message is displayed:
The enable secret is a password used to protect access to
privileged EXEC and configuration modes. This password, after
entered, becomes encrypted in the configuration.
Enter enable secret:
Step 6
Enter an enable secret password. This password is encrypted and cannot be seen when viewing the
configuration.
The following message is displayed:
The enable password is used when you do not specify an
enable secret password, with some older software versions, and
some boot images.
Enter enable password:
Step 7
Enter an enable password that is different from the enable secret password. This password is not encrypted
(and is less secure) and can be seen when viewing the configuration.
The following message is displayed:
The virtual terminal password is used to protect
access to the router over a network interface.
Enter virtual terminal password:
Step 8
Enter the virtual terminal password and press Enter. The virtual terminal password prevents unauthenticated
access to the gateway through ports other than the console port. The following message is displayed:
Configure SNMP Network Management? [no]:
Community string [public]:
Step 9
Enter yes.
A summary of the available interfaces is displayed, as shown in the following example:
Current interface summary
Interface IP-Address OK? Method Status Protocol
GigabitEthernet0/0 unassigned YES NVRAM administratively down down
GigabitEthernet0/1 10.10.10.12 YES DHCP up up
Any interface listed with OK? value "NO" does not have a valid configuration
Step 10
Select one of the available interfaces to connect the voice gateway to the management network. In the following
example, gigabitethernet0/1 is selected:
Enter interface name used to connect to the
management network from the above interface summary: gigabitethernet0/1
Step 11
Respond to the following prompts as appropriate for your network:
Configuring interface GigabitEthernet0/1:
Configure IP on this interface? [yes]: yes
IP address for this interface [10.10.10.12]:
Cisco VG310 and Cisco VG320 Voice Gateways Hardware Installation Guide
56 OL-31292-01
Configuring the Cisco VG310 and Cisco VG320 Voice Gateways
Using the setup Command Facility
To Next Page
Loading...
Need help?
General
