30-13
Catalyst 3750 Switch Software Configuration Guide
78-16180-02
Chapter 30 Configuring SNMP
Configuring SNMP
You can use the snmp-server host global configuration command to a specific host to receive the
notification types listed in Table 30-5.
Table 30-5 Switch Notification Types
Notification Type
Keyword Description
bgp Generates BGP state change traps. This option is only available when the
enhanced multilayer image is installed.
bridge Generates STP bridge MIB traps.
cluster Generates a trap when the cluster configuration changes.
config Generates a trap for SNMP configuration changes.
config-copy Generates a trap for SNMP copy configuration changes.
entity Generates a trap for SNMP entity changes.
envmon Generates environmental monitor traps. You can enable any or all of these
environmental traps: fan, shutdown, supply, temperature.
flash Generates SNMP FLASH notifications. You can optionally enable
notification for flash insertion or removal, which would cause a trap to be
issued whenever a switch in the stack is removed or inserted (physical
removal, power cycle, or reload).
fru-ctrl Generates entity FRU control traps. In the switch stack, this trap refers to the
insertion or removal of a switch in the stack.
hsrp Generates a trap for Hot Standby Router Protocol (HSRP) changes.
ipmulticast Generates a trap for IP multicast routing changes.
mac-notification Generates a trap for MAC address notifications.
msdp Generates a trap for Multicast Source Discovery Protocol (MSDP) changes.
pim Generates a trap for Protocol-Independent Multicast (PIM) changes. You can
enable any or all of these traps: invalid PIM messages, neighbor changes, and
rendezvous point (RP)-mapping changes.
port-security Generates SNMP port security traps. You can also set a maximum trap rate
per second. The range is from 0 to 1000; the default is 0, which means that
there is no rate limit.
rtr Generates a trap for the SNMP Response Time Reporter (RTR).
snmp Generates a trap for SNMP-type notifications for authentication, cold start,
warm start, link up or link down.
stpx Generates SNMP STP Extended MIB traps.
syslog Generates SNMP syslog traps.
tty Generates a trap for TCP connections. This trap is enabled by default.
vlan-membership Generates a trap for SNMP VLAN membership changes.
vlancreate Generates SNMP VLAN created traps.
vlandelete Generates SNMP VLAN deleted traps.
vtp Generates a trap for VLAN Trunking Protocol (VTP) changes.
To Next Page
Loading...
