36-52
Catalyst 3750 Switch Software Configuration Guide
78-16180-02
Chapter 36 Configuring IP Multicast Routing
Monitoring and Maintaining IP Multicast Routing
Monitoring IP Multicast Routing
You can use the privileged EXEC commands in Table 36-6 to monitor IP multicast routers, packets, and
paths:
show ip mpacket [source-address | name]
[group-address | name] [detail]
Display the contents of the circular cache-header
buffer.
show ip mroute [group-name | group-address]
[source] [summary] [count] [active kbps]
Display the contents of the IP multicast routing
table.
show ip pim interface [type number] [count] Display information about interfaces configured
for PIM.
show ip pim neighbor [type number] List the PIM neighbors discovered by the switch.
show ip pim rp [group-name | group-address] Display the RP routers associated with a
sparse-mode multicast group.
show ip rpf {source-address | name} Display how the switch is doing Reverse-Path
Forwarding (that is, from the unicast routing table,
DVMRP routing table, or static mroutes).
show ip sdr [group | “session-name” | detail] Display the Session Directory Protocol Version 2
cache.
Table 36-5 Commands for Displaying System and Network Statistics (continued)
Command Purpose
Table 36-6 Commands for Monitoring IP Multicast Routing
Command Purpose
mrinfo [hostname | address] [source-address |
interface]
Query a multicast router or multilayer switch about
which neighboring multicast devices are peering
with it.
mstat source [destination] [group] Display IP multicast packet rate and loss
information.
mtrace source [destination] [group] Trace the path from a source to a destination
branch for a multicast distribution tree for a given
group.
To Next Page
Loading...
Need help?
General