Index
IN-7
Catalyst 3750 Switch Software Configuration Guide
78-16180-02
clusters, switch (continued)
compatibility
6-4
creating 6-17
creating a cluster standby group 6-20
described 6-1
LRE profile considerations 6-17
managing
through CLI
6-23
through SNMP 6-24
planning 6-4
planning considerations
automatic discovery
6-5
automatic recovery 6-10
CLI 6-23
host names 6-13
IP addresses 6-13
LRE profiles 6-17
passwords 6-14
RADIUS 6-16
SNMP 6-14, 6-24
switch-specific features 6-17
switch stacks 6-14
TACACS+ 6-16
redundancy 6-20
troubleshooting 6-22
verifying 6-22
See also candidate switch, command switch, cluster
standby group, member switch, and standby
command switch
cluster standby group
and HSRP group
35-11
automatic recovery 6-12
considerations 6-11
creating 6-20
defined 6-2
requirements 6-3
virtual IP address 6-11
See also HSRP
CMS
benefits
1-2
configuration modes 3-5
described 1-2, 1-4
downloading image files 1-2, 3-16, B-20
Front Panel view, described 3-2
operating systems and supported browsers 3-9
privilege levels 3-7
requirements 3-8 to 3-9
Topology view 3-15
wizards 3-6
Coarse Wave Division Multiplexer
See CWDM SFPs
command-line interface
See CLI
command modes
2-1
commands
abbreviating
2-3
no and default 2-4
setting privilege levels 9-8
command switch
accessing
6-11
active (AC) 6-10, 6-20
command switch with HSRP disabled (CC) 6-21
configuration conflicts 39-12
defined 6-2
enabling 6-17
passive (PC) 6-10, 6-21
password privilege levels 6-23
priority 6-10
recovery
from command-switch failure
6-10, 39-9
from lost member connectivity 39-12
redundant 6-10, 6-20
replacing
with another switch
39-11
with cluster member 39-9
To Next Page
Loading...
Need help?
General