Citizen CL-S521 - Page 36

36
Chapter 2 Printer Operation
Top Menu Sub Menu Default Menu Remarks
Emulation Select ZPI2 DM4
DMI
DPP
ZPI2
Selects DataMax®/Zebra® compatibility
DM4: DataMax® 400
DMI: DataMax® IClass
DPP: DataMax® Prodigy Plus®
ZPI2: Zebra® Emulation
Emulation Auto
Detect
On On
O
Full Auto
Selects the detection of Datamax® and
Zebra® emulation.
After Print AutoCongure On On
O
Optional auto congure
On .....Auto congure eective.
If a peeler unit or auto-cutter is
installed, each mode is automatically
set regardless of the “function select”
setting.
O ....Auto congure ineective.
When a peeler unit or auto-cutter is
installed but has not been started, it
is o and the operation is selected by
“Function select”.
Function Select Tear O
Tear
Peel On*
Cut On*
Selects the type of options installed and
adjusts the “paper stop” position accordingly.
For example, the position where the label
stops in “Tear” mode is dierent to that in
“Peel On” mode.
Cutter Action* Backfeed Backfeed
Through
Cutter operating method setting
Backfeed: it feeds back after each cutting
operation.
Through: when the number copied = n, the
back end of sheet 1 to n-1 passes through,
and the back end of the nal page that is a
single sheet is copied and fed back.
Paper Position 0.00 inch
0.0 mm
Peel/Cut/Tear O
0.00 to 2.00 inch
0.0 to 50.8 mm
Peel/Cut/Tear On
-1.00 to 1.00 inch
-25.4 to 25.4 mm
The stop position can be ne tuned using
this menu setting. The general stop position
is selected depending on the “Function”
selected above.
Mode/Repeat Key Disabled LastOne
Disabled
Repeat method selection
LastOne:
Issues only the nal page.
In count case, it issues only 1 label while
continuing.
Disabled:
Makes the repeat key invalid.
* Eective only when the optional unit is attached.
Mode Settings
[Zebra® Emulation]