3-6. Adjustments
3-41 CLP-621 & CLP-631 3-41 CLP-621 & CLP-631
Key operation on the printer: Key operation on the printer:
PAUSE
STOP
FEED
MODE/REPEAT
DOWN
(Previous item / Decrease item)
EXIT
UP
(Next item / Increase item)
SELECT
(2-2) Adjustment procedures (2-2) Adjustment procedures
Caution: Caution:
• DO NOT adjust other menus not explained here. They are for factory setup use
and changing them will cause the printer to be defective.
• DO NOT adjust other menus not explained here. They are for factory setup use
and changing them will cause the printer to be defective.
Notes: Notes:
• Do not turn OFF the power of the printer until you finish the adjustment. If it is turned
OFF, you need to repeat the adjustment from the beginning.
• Do not turn OFF the power of the printer until you finish the adjustment. If it is turned
OFF, you need to repeat the adjustment from the beginning.
• The value adjusted here is retained until you change it with the same procedure. Even if
you perform initialization in the “user menu setup mode”, it is not initialized.
• The value adjusted here is retained until you change it with the same procedure. Even if
you perform initialization in the “user menu setup mode”, it is not initialized.
1. Turn on the PC and run the Terminal software. 1. Turn on the PC and run the Terminal software.
2. While pressing and holding the [MODE], [FEED] and [STOP] key, turn on the power. 2. While pressing and holding the [MODE], [FEED] and [STOP] key, turn on the power.
([MODE] + [FEED] + [STOP] + [POWER]) ([MODE] + [FEED] + [STOP] + [POWER])
3. The following initial maintenance screen will appear on the PC. 3. The following initial maintenance screen will appear on the PC.
[Transparent sensor sensitivity adjustment, Media: Label paper]
4. Press the [FEED] key to select the transparent sensor menu (“Ini Thru Sensor”).
To Next Page
Loading...
