— 21 —
ESC > n
[Function] Saving current setting
[Code] <1B>H<3E>H<n>
[Range] n = 0 or 1
[Outline] This command saves International character, Serial port baud rate, Print density, Auto
power off time and maximum speed at Infrared communication to NV memory so
that the setting can be resumed automatically when power on after setting data on
RAM memory is gone by like battery is disconnected.
[Caution] Do NOT use this command frequently.
NEVER turn the printer off during command is running. Otherwise there is a risk to
lose the firmware updating function.
Power is turned off automatically when setting is saved.
[Default] n = 0
[See Also] ESC R, ESC S, ESC Y, ESC x
n (Hex) Type
0 Max speed at Infrared communication is 115200 bps.
1 Max speed at Infrared communication is 57600 bps.
To Next Page
Loading...
