— 22 —
ESC ? n
[Function] Reading magnetic stripe reader
[Code] <1B>H<3F>H<n>
[Range] {0 =< n =< 7(Hex)}
[Outline] When the command is received the bicolor LED is shining in RED and the printer is
waiting for the magnetic card to be swiped through the reader. If even after 10
seconds the card is not swiped the command is aborted automatically.
Printer returns the information read from the tracks followed by 00(Hex).
Reads the data of the track in the following table by the value of n.
n (Hex) Track
0Invalid
1Track 1
2Track 2
3Track 1 and 2
4Track 3
5Invalid
6Track 2 and 3
7Invalid
The format of the data read is as follows.
Track Header Card data Footer
Track Track 1 is F1 (Hex)
Track 2 is F2 (Hex)
Track 3 is F3 (Hex)
Header Track 1: “%”
Track 2: “;”
Track 3: “+” or “;”
Card data ASCII data
Footer “?”
If reading track is more than one (n=3 or 6), footer data of track 1 or 2 is followed by
track data of track 2 or 3.
[Caution] The command for reading multiple tracks at a time may often result in read error.
If reading is unsuccessful, repeat it.
To Next Page
Loading...
Need help?
General
