— 46 —
GS H n
[Function] Selecting of Printing Position of HRI Code
[Code] <1D>H<48>H<n>
[Range] {0 =< n =< 3(Hex)}
[Outline] Selecting printing position of HRI code in printing bar codes.
• “n” means the followings.
The HRI code refers to the bar code-turned characters so that you can read them.
[Caution] The HRI code is printed in the font selected with GS f. Specify before the GS k
command.
[Default] The initial value of n is “0”.
[See Also] GS f
[Sample Program]
PRINT #1, CHR$ (&H1B) + “3” + CHR$ (5);
PRINT #1, CHR$ (&H1D) + “h” + CHR$ (50);
PRINT #1, CHR$ (&H1D) + “H” + CHR$ (0);
GOSUB BC
PRINT #1, CHR$ (&H1D) + “H” + CHR$ (1);
GOSUB BC
PRINT #1, CHR$ (&H1D) + “H” + CHR$ (2);
GOSUB BC
PRINT #1, CHR$ (&H1D) + “H” + CHR$ (3);
GOSUB BC
END
BC:
PRINT #1, CHR$ (&H1D) + “k”;
PRINT #1, CHR$ (4);
PRINT #1, “12” + CHR$ (0);
PRINT #1, CHR$ (&HA);
RETURN
[Print Results]
n (Hex) Printing Position
0 No printing
1 Above the bar code
2 Below the bar code
3 Both above and below the bar code
No Visible Code
Printed above
Printed below
Printed above and below
To Next Page
Loading...
Need help?
General
