— 51 —
GS a n
[Function] Enabling/Disabling ASB (Automatic Status Back)
[Code] <1D>H<61>H<n>
[Range] {0 =< n=< FF(Hex)}
[Outline] This command selects the status item to be addressed by ASB (Automatic Status
Back.)
BIT7
BIT6 BIT5 BIT4 BIT3 BIT2 BIT1 BIT0
Not in use (0)
Not in use (0)
Not in use (0)
Not in use (0)
Not in use (1)
Not in use (0)
The paper is fed manually by LF switch
Not in use (0)
When this command is executed, the printer will return 4 bytes with status information,
with the follwoing meaning:
BYTE 1
Bit Status Item Addressed by ABS
0 Not defined
1 Defining LF button function
2 Thermal head temperature status
3 Paper end sensor and paper cover open status
4 Not defined
5 Not defined
6 Not defined
7 Not defined
To Next Page
Loading...
Need help?
General
