PMU2300III Series Service Manual
- 9 -
3. Removing “SA, SENSOR”
1. Remove two “SPONGE, BEZEL” that fasten “SA, SENSOR” and remove “SA, BOARD BEZEL”
from “BEZEL”.
SPONGE, BEZEL
When reassembling, align “SA,
BOARD BEZEL” with the right and
left grooves at “BEZEL”.
Disconnect “SA, LED CABLE”
from the connector.
SA, BOARD LED
When reassembling, move “SPONGE,
BEZEL” inwardly so that “SA, BOARD
LED” will not be raised.
To Next Page
Loading...
