PMU2300III Series Service Manual
- 15 -
1-2-5. Disassembling “PLATEN ASSY”
1. Removing “GUIDE, FRONT” (SB Specification)
1. Remove two “Screw, PHT (ST), M3 × 6” and remove “GUIDE, FRONT” from “HOLDER2,
PLATEN UNIT”.
2. Removing “GUIDE, ROLLER FRONT ASSY” (PN or PB Specification)
1. Remove two “Screw, PHT (ST), M3 × 6” and remove “GUIDE, ROLLER FRONT ASSY” from
“HOLDER2, PLATEN UNIT”.
3. Removing “PLATE, SIDE R” and “PLATE, SIDE L” (PN or PB Specification)
1. Remove two “Screw, PHT (ST), M3 × 6” form each of “PLATE, SIDE R” and “PLATE, SIDE L”,
respectively, and remove them from “FRAME 1”.
GUIDE, FRONT
HOLDER2, PLATEN UNIT
Screw, PHT (ST), M3 × 6
GUIDE, ROLLER FRONT ASSY
Screw, PHT (ST), M3 × 6
HOLDER2, PLATEN UNIT
When reassembling, align the bosses
at “PLATE, SIDE R” and “PLATE,
SIDE L” with the holes at “FRAME 1”.
Hole for boss
PLATE, SIDE R
Screw, PHT (ST), M3 × 6
FRAME 1
PLATE, SIDE L
To Next Page
Loading...
