Citizen PMU2300III Series

PMU2300III Series Service Manual
- 17 -
1-2-6. Disassembling “UNIT, MECHANISM”
1. Removing “FRAME 1”
1. Remove two “Screw, PHT (ST), M3 × 6” and remove “FRAME 1” from “PLATE PRINTER”.
2. Removing “PLATE PRINTER”
1. Pull the FFC cable out of “UNIT, MECHANISM”.
2. Cut the cable tie and remove filament tapes at the right and left.
When reassembling, insert the
lugs at “FRAME 1” into the
notches at “PLATE PRINTER”.
When reassembling, be careful not to
cause the FFC cable to get caught.
FRAME 1
Screw, PHT (ST), M3 × 6
PLATE PRINTER
FRAME 1
When reassembling, fully
insert the FFC cable in the
correct orientation.
FFC cable
When reassembling, do not attach filament
tapes out of “PLATE, PRINTER”.
When reassembling, locate the protruded
section of the cable tie outwardly.
When reassembling, hang motor
cables to the lug and secure them
with a piece of tape. Check that a
black tube is attached to the lug.
Cable tie
Filament tapes