Citizen PMU2300III Series

PMU2300III Series Service Manual
- 63 -
6-2. Hex-dump Mode
1) Function
This function is used to print data sent from a host in hexadecimal with corresponding
characters.
2) Starting the hex-dump mode
Turn the power on while holding down the FEED switch with the paper set and the platen
opened, and then close the platen.
Alternatively, specify the dedicated command “GS(A”. After “HEX DUMP PRINT MODE” is
printed on the roll paper, received data is printed out in hexadecimal with corresponding
characters.
(* Refer to the command reference “GS(A”.)
ＨＥＸダンプ印字モード
1B 40 31 32 33 34 35 36 .@123456
37 38 39 30 0A 7890.
Completed
HEX DUMP PRINT MODE
1B 40 31 32 33 34 35 36 .@123456
37 38 39 30 0A 7890.
Completed
(MSW9-3 is set to ON (kanji enabled),
for use in Japan)
(MSW9-3 is set to ON (kanji disabled),
for use in other countries)
• In the hex-dump mode, any command other than real-time commands is disabled.
• When printed data is less than one line, printing is executed in the off-line mode.
3) Ending the hex-dump mode
• Press the FEED switch three times consecutively.
“Completed” is printed out and paper is fed to the paper cut position. Then the printer is
reset.
• Reset the printer by turning the power off or by the I/F signal.