Citizen PMU2300III Series

PMU2300III Series Service Manual
- 8 -
1-2-2. Disassembling “BEZEL ASSY” (SB Specification)
1. Removing “BEZEL ASSY”
1. Remove four “Screw, PHT (ST#3), M2 × 5” and remove “BEZEL ASSY” from “AUTO CUTTER”.
2. Cut the cable tie that secures cables to the side frame, and remove “BEZEL ASSY".
2. Removing “HOLDER, FLAG”
1. Remove two “Screw, PHT (PT2T), M2 × 4” and remove “HOLDER, FLAG” from “BEZEL”.
2. Remove “E-RING, 1.5” that fastens “FLAG, SENSOR” and remove “FLAG, SENSOR” from
“HOLDER, FLAG”.
AUTO CUTTER
Screw, PHT (ST#3), M2 × 5
BEZEL ASSY
Screw, PHT (PT2T), M2 × 4
HOLDER, FLAG
E-RING, 1.5
When reassembling, hang
“SPRING, FLAG” to the notch
at “FLAG, SENSOR”.
FLAG, SENSOR
SPRING, FLAG