Citizen PMU2300III Series

PMU2300III Series Service Manual
- 28 -
2. MEMORY SWITCH SETTING
In addition to the memory switch setting, the following data is registered in the printer before shipment
according to the model name. (Refer to the separate product specification sheet.)
• Model name to be printed by self-printing
• ROM version to be printed by self-printing
• Default settings
The data shown above will not affect the printer functions directly. The printer functions can be set using the
memory switch.
• Basic model
The basic model is configured with the memory switch settings shown below. The printer can work
normally only when the memory switch is correctly set.
Table: Memory switch setting for basic model
Model name
MSW11-1
Presenter function
MSW12-1
Bezel function
PMU2300IIISN, standard specification OFF
PMU2300IIISB, bezel specification
OFF
ON
PMU2300IIIPN, presenter specification OFF
PMU2300IIIPB, presenter + bezel specification
ON
ON
• Destination
According to the destination, the memory switch is set as shown below.
Table: Memory switch setting for destination
Destination
MSW9-1
Code page
MSW9-2
International character
MSW9-3
Kanji
Japan J Katakana Japan Valid
North America, Europe, others U PC437 U.S.A Invalid
• Paper type
According to the paper type, the memory switch is set as shown below.
Table: Memory switch setting for paper
Paper
MSW3-4
Paper type
Standard (no marking) OFF Heat-sensitive paper
Black mark specification M1 (M2) ON Black mark paper
When a special paper holder “PHU-102S” or “PHU-230T” is used, the PNE sensor is enabled or disabled
by the memory switch.