PMU2300III Series Service Manual
- 10 -
1-2-3. Disassembling “BEZEL PRESENTER ASSY” (PB Specification)
1. Removing “BEZEL ASSY”
1. Remove two “Screw, PHT (ST), M3 × 6” and remove “BEZEL PRESENTER ASSY” from
“PRESENTER UNIT”.
2. Cut the cable tie that secures cables to the side face of “SA, Chassis”. Detach the cables from
the hook on “COVER, GEAR” and remove “BEZEL PRESENTER ASSY”.
2. Removing “PLATE, BEZEL”
1. Remove two “Screw, PHT (BT), M3 × 8” and remove “BEZEL, PRESENTER” from “PLATE,
BEZEL”.
When reassembling, check that the bosses
at “BEZEL PRESENTER ASSY” are securely
fitted with the holes at “PRESENTER UNIT”.
BEZEL PRESENTER ASSY
Screw, PHT (ST), M3 × 6
Hole for boss
Cut.
SA, Chassis
HOOK
COVER, GEAR
When reassembling, check that the bosses on the
right and left at “BEZEL, PRESENTER” are
securel
fitted with the holes at “PLATE, BEZEL”.
Screw, PHT (BT), M3 × 8
PLATE, BEZEL Hole for boss
To Next Page
Loading...
