Citizen PMU2300III Series

PMU2300III Series Service Manual
- 20 -
1-2-7. Disassembling “UNIT, Paper Holder (PHU-102S)”
1. Removing “Plate, Paper Holder”
1. Remove two “Screw, PHT (ST), M3 × 6” that fasten “Plate Paper Holder”.
2. Removing “Stopper Paper Plate”
1. Remove “Screw, PHT (ST), M3 × 6”, “WASHER, PLAIN, 3 × 8 × 0.5” and “NUT, (#3), M3” that
fasten “Stopper Paper Plate”.
3. Removing “PNE, SENSOR”
“PNE SENSOR” is attached to the right and left in the same manner.
1. Remove “SCREW, PHT M3 × 3 (ST)” and “WASHER, PLAIN, 3 × 8 × 0.5” from “Plate Paper
Holder”.
Remove “SA, PNE SENSOR” from “Cord Holder”.
Plate Paper Holder
Screw, PHT (ST), M3 × 6
• Screw, PHT (ST), M3 × 6
• WASHER, PLAIN, 3 × 8 × 0.5
• NUT, (#3), M3
Stopper Paper Plate
Disconnect the connector
from CN108.
• SCREW, PHT M3 × 3 (ST)
• WASHER, PLAIN, 3 × 8 × 0.5
SA, PNE SENSOR
Cord Holder