PMU2300III Series Service Manual
- 23 -
2. Remove “EXT SPRING-03” that is attached between “COVER, LEVER” and “TENSION,
LEVER”.
* Common to PHU102S and PHU-203T
TENSION, LEVER
EXT SPRING-03
COVER, LEVER COVER, LEVER
* When reassembling, draw the cable of
“PNE Sensor” through the hole between
two screws that fasten “Plate Paper
Holder”, and connect it to “Board Main”.
* When reassembling, connect the cable to
CN108 on “Board Main”. (Since the shape
is the same as CN109, be careful not to
connect the cable to CN109.)
CN108
When reassembling, align the bosses
at “TENSION LEVER” with the
grooves on “COVER, LEVER”.
To Next Page
Loading...
